Important Safety Information - Hatco Ultra-Glo UGA Series Installation And Operating Manual

Read the following important safety information before using this equipment to avoid
serious injury or death and to avoid damage to equipment or property.
WARNING
ELECTRIC SHOCK HAZARD:
• For hard-wired
connections must be in accordance with
local electrical codes and any other
applicable codes. Connections should be
made by a qualified, licensed electrician.
• Turn the power OFF at the fused disconnect
switch/circuit breaker and allow the unit to
cool before performing any maintenance or
cleaning.
• DO NOT submerge or saturate with water.
Unit is not waterproof. Do not operate if unit
has been submerged or saturated with water.
• This unit is not "jet-proof" construction. Do
not use jet-clean spray to clean this unit.
• Use only Genuine Hatco Replacement Parts
when service is required. Failure to use
Genuine Hatco Replacement Parts will void
all warranties and may subject operators of
the equipment to hazardous electrical
voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are
specified to operate
environments in which they are used. Some
aftermarket or generic replacement parts do
not have the characteristics that will allow
them to operate safely in Hatco equipment.
FIRE HAZARD:
• Do not install Ultra-Glo ceramic strip heaters
above or around combustible surfaces.
Discoloration or combustion could occur.
Ultra-Glo ceramic strip heaters must be
installed in non-combustible surroundings
only.
• Do not store or use gasoline or other
flammable vapors or liquids in the vicinity of
this or any other appliance.
Use only light bulbs that meet or exceed
National Sanitation Foundation (NSF) standards
and are specifically designed for food holding
areas. Breakage of light bulbs not specially
coated could result in personal injury and/or
food contamination.
This unit has no "user-serviceable" parts. If
service is required on this unit, contact an
Authorized Hatco Service Agent or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966; or International
fax 414-671-3976.
Form No. UGAM-0908
All manuals and user guides at all-guides.com

IMPORTANT SAFETY INFORMATION

units, all electrical
safely in the
BURN HAZARD: Some exterior surfaces on the
unit will get hot. Use caution when touching
these areas.
Standard and approved manufacturing oils may
smoke up to 30 minutes during initial startup.
This is a temporary condition. Operate unit
without food product until smoke dissipates.
To ensure safe and proper operation, refer to the
"Minimum Clearance Requirements" listed in
the INSTALLATION section of this manual.
Installation of two or more separate units with
less than 3" (76 mm) between housings may
result in premature failure of component parts.
Failure to provide proper spacing may result in
heat damage to electrical components.
To prevent unit failure, do not add a decorative
soffit to hide a pass-through mounted strip
heater.
To prevent premature failure of components due
to excessive heat, remote control enclosures
must be installed outside the strip heater heat
zone.
Heat damage to countertop material such as
Corian and similar products (other than
®
stainless steel) is not covered under the Hatco
warranty. Contact the manufacturer of the base
material for temperature limits and application
information before installing the unit.
Use non-abrasive cleaners only. Abrasive
cleaners could scratch the finish of the unit,
marring its appearance
susceptible to dirt accumulation.
1
CAUTION
NOTICE
and making it