Advertisement
INSTALLATION
A. To Remove Existing Toilet
Turn off the water supply. Flush the toilet, and use a sponge to remove the remaining water from the tank and
bowl. Disconnect the supply shut-off valve (if present), and remove the old tank and bowl.
Remove old gasket from the floor and closet flange with a putty knife. Remove old T-bolts and discard them.
NOTICE:if a new toilet is not installed
immediately, temporarily stuff a rag in
the closet flange.
B. Roughing-In
DANGER:Risk of electric shock.Disconnect power before servicing.
NOTE.This product is designed for installation with the electrical supply and water pipeline
located through the wall.It is shown in the roughing-in.
WARNING: Risk of electric shock.Connect only to circuits protected by Ground-Fault Circuit-Interrupters
(GFCI s) or Earth-Leakage Circuit-Breakers (ELCB s).
Warning: before installation, please confirm floor and flange is connected by expansion bolt.
Keep bath and shower away from electrical parts (such as remote controller, receptacle, audio input appara-
tus and so on).
If the socket is wall-mounted , a GFCI or ELCB protected and water proof receptacle is required.
Follow the dimensional information exactly when installing a hardwire electrical supply.
Floor Flange
Kohler Co.
Supply Stop
T-Bolts
Closet Flange
Fig.#7
The wall location of the electrical supply and water
supply are interchangeable.
GFCI-Protected 10A Receptacle(water proof)
Fig.#8
7
1303729-T01-G
Advertisement
