Advertisement
BEFORE YOU BEGIN
Please read these instructions carefully to familiarize yourself with the required tools, materials, and installation
sequences. Follow the sections that pertain to your particular installation. This will help you avoid costly mistakes. In
addition to proper installation, read all operating and safety instructions.
All information in these instructions is based upon the latest product information available at the time of publication.
Kohler China reserves the right to make changes in product characteristics, packaging, or availability at any time
without notice.
These instructions contain important care, cleaning, and warranty information - please leave instructions for the
consume.
We appreciate your commitment to Kohler quality. Please take a few minutes to review this manual before you start
installation. If you encounter any installation or performance problems, please don t hesitate to contact us. Thanks
again for choosing Kohler Company.
Please make sure there is enough space for toilet installation, and it will not influence door swing.
When install the product in the room, a stop valve shall be installed in a close proximity. For emergency circumstances,
the water inlet valve shall be stopped without using any tools; otherwise unexpected failure may cause the loss to the
customer.
Confirm discharge pit dimension distance is 305mm, pit dimension distance must be 292-350mm or the installation will
be compromised.
Confirm water supply stop must extend no more than 3mm beyond the finished wall or sink no more than 5mm below
finished wall or the installation will be compromised.
DN15mm or larger main water pipe is recommended to ensure following water supply requirements.
NOTES
DANGER: Risk of electric shock.Disconnect power before servicing.
WARNING: Risk of electric shock.Connect only to circuits protected by Ground-Fault Circuit-
Interrupters (GFCI s) or Earth-Leakage Circuit-Breakers (ELCB s).
CAUTION: Risk of hazardous gases.If a new toilet is not installed immediately, temporarily place
a rag in the floor flange opening.
NOTICE: Follow all local plumbing and electrical codes.
NOTICE:Receptacles installed in bathrooms to be located at least 1 meter from a bathtub or shower if
practical.
WARNING: Risk of electric shock for hardwire installations/through-floor electrical supply:
Connect only to dedicated 220V~, 50Hz, 10A circuit protected by Ground-Fault Circuit-Interrupters
(GFCI's) or Earth-Leakage Circuit-Breakers (ELCB's).
WARNING: Must use 10A receptacle.
1303729-T01-G
Observe all local plumbing and building codes.
Carefully inspect the new toilet for damage.
Water and electrical supplies may be wall mounted.
KARING 2.0 INTELLIGENT TOILET
KARING 2.0 INTELLIGENT TOILET(IOT)
2
I NSTALLATION INSTRUCTIONS
K-77780T-0
K-77780T-XP-0
Kohler Co.
Advertisement
