Troubleshooting - CDA SV430 Manual For Installation, Use And Maintenance

Troubleshooting

If the oven is not functioning correctly, check the advice below prior to calling CDA Customer Care.
Problem
The oven does not heat up
The padlock on the display is flashing
The oven light is not working
The oven starts beeping during cooking
The oven starts beeping at the end of
the cooking programme
The cooling fan continues to run after
the programme ends
The oven display will show error codes if there is a fault with the appliance. These are detailed below. Before calling CDA
Customer Care, take note of the error code as this will help when attempting to resolve the problem.
Error Code Fault
F01 Temperature sensor error
F02 Overheated oven . First ensure there is adequate ventilation to the oven as described on page 14.
F04 Door interlock
F05 Other cooking fault
F10 Information only – power cut during cooking
Auto stop. The oven is equipped with an auto stop function to automatically switch off the oven if it is in
AUTO
continuous use for more than 23 hours and 30 minutes.
Possible Cause
There is no power supply to the oven
Door lock system fault
Light fault
Advice
Check the oven is switched on at the
cooker point and the fuse/circuit
breaker has not activated.
Call CDA Customer Care
Call CDA Customer Care
The oven is at the required temperature
The programme has finished
The fan will run up to one hour after
cooking, or when the oven temperature
is above 125˚ C
If the fan continues to run more than
90 minutes after use, then call CDA
Customer Care
12