Table of Contents
Advertisement
Touch the Start/Pause
lock the door and starts the countdown of the delay
start. The display shows the indicator
When the countdown is completed, the programme
starts automatically.
2. Touch the Start/Pause
appliance. The related indicator flashes.
3. Touch the Delay Start
until the display shows
goes off.
4. Touch the Start/Pause
the programme immediately.
Changing the delay start after the countdown
has started
To change the delay start:
1. Touch the Start/Pause
appliance. The related indicator flashes.
2. Touch the Delay Start
until the display shows the desired delay time.
3. Touch the Start/Pause
the new countdown.
THE AUTOADJUST SYSTEM LOAD
DETECTION
The programme duration in the display
is referred to a medium/high load.
After touching the Start/Pause
maximum declared load indicator goes off, the
AutoAdjust System starts the laundry load
detection:
1. The appliance detects the load in the first 30
seconds. In the programmes where Flextime is
available, during this phase the Flextime bars
placed below the time digits play a
simple animation. The drum rotates shortly.
2. The programme duration could be adjusted
accordingly and could increase or decrease.
After further 30 seconds, the water filling
starts.
At the end of the load detection, in case of drum
overload, the indicator
display:
In this case, for 30 seconds, it is possible to pause
the appliance and remove the exceeding garments.
Once removed the exceeding garments, touch the
Start/Pause
button to start the programme
again. The AutoAdjust phase can be repeated up to
three times (see point 1).
button. The appliance
.
button to pause the
button repeatedly
and the indicator
button again to start
button to pause the
button repeatedly
button again to start
button, the
is flashing in the
Important! If the laundry amount will not be
reduced, the washing programme starts anyway,
despite the overload. In this case, it will be not
possible to guarantee the best washing results.
About 20 minutes after the programme
start, the programme duration could
be adjusted again depending on the
capacity of water absorption of the
fabrics.
The AutoAdjust detection is carried
out with complete washing
programmes only and if the
programme duration has not been
reduced by means of the Flextime
button.
The AutoAdjust System is not available
with all programmes such as :Wool/
Handwash, Rinse and programmes
with short cycles.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
When the programme is running, you can change
only some options:
1. Touch the Start/Pause
The related indicator flashes.
2. Change the options. The given information in
the display changes accordingly.
3. Touch the button Start/Pause
The washing programme continues.
CANCELLING A RUNNING PROGRAMME
1. Press the button On/Off to cancel the
programme and to deactivate the appliance.
2. Press the button On/Off again to activate the
appliance.
If the AutoAdjust System has
completed and the water filling has
already started, the new programme
starts without repeating the
AutoAdjust System. The water and
the detergent are not drained out in
order to avoid waste. The display
shows the maximum duration of the
programme, updating it about 20
minutes after the starting of the new
programme.
There is also an alternative way of cancelling:
1. Rotate the selector knob to the "Reset" position
.
button.
again.
27
Advertisement
Table of Contents
