How To Use; Direct Power Keys; Boost/Precook - CDA INDUCTION HOB HVN61/81 Installation & Use Manual

Using your Hob
To switch the zone on
• Touch the key for the zone required. The zone display will flash 0 and the hob will beep to confirm the hob is on.
Please note: If a power level is not set within five seconds, the zone will switch off automatically.
To set the power level
• Touch the key to increase the power level from 1 (lowest) to 12 (maximum), and the
• To go straight to 12, touch the
To turn the power off
• Touch the key for the zone used or reduce the power level on the zone by touching the
display switches off.

Direct power keys

• The hob is equipped with two keys to allow access to a specific power level for ease of use.
• After turning the power on for the zone required, touch either of the direct power keys as shown below. To change to any
other power level, touch either
Low heat
High heat
• It is possible to adjust the direct power keys if necessary. To do so, when the hob is switched off, touch the direct power
key for approximately five seconds until the hob beeps and the display shows the current power level. Then touch the
or keys until the zone display shows the required power level. The hob will beep after approximately three seconds
to confirm the new power level has been set.
Boost
• The hob is equipped with a boost function once the zone is switched on, allowing a higher power level than power level 12
for an unspecified length of time. To turn on the boost function, touch the
the pan has reached the temperature required, then select the required power level by touching any of the power level keys
, or .
Please note:
• The boost function does not switch off automatically. You must set a power level when boost is no longer required.
Precook (preheat function for power levels 6-12)
• Touch and hold the key until the zone display shows 12 and then touch the
for five seconds during which you must set the power level required, as described above. The hob will beep to confirm the
selection, and the zone display will alternate between the power level set and PC.
• To cancel the precook and return to normal cooking, set the power level required using the power keys
Please note:
Using the boost or precook function on one zone automatically limits the power level available to the other zone on the same
side. If you wish to use several pans at the same time, try to use zones on opposite sides.
key when the zone is switched on.
or keys until the required power level is shown on the zone display.
Power level 6
Power level 10
key to reduce it.
key until the zone
key. bo will show on the zone display. When
key again. The zone display will show PC
, , or .