Fstepdrv - Canon REALiS SX6 User Manual

User Command Specifications
1

FSTEPDRV

FSTEPDRV
Commands
Function Focus lens step drive control
Format FSTEPDRV=<Focus lens step control parameter：ＩＤ>
Parameter Focus lens step control parameters
Parameter
FAR
NEAR
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the
Response "i:OK" is returned when zooming was completed successfully after step drive.
For all other responses, refer to
Description This command is used to drive the focus lens.
(1) It can be executed when the projector is in both the remote mode and power-on status at the same
time.
However, a "busy" response is given while the zoom or focus lens is being driven.
（ Refer to the
(2)
This command functions in the same way as when first the "FOCUS" button on the remote control
or main unit panel is pressed and then the "←" or "→" button is pressed.
(3)
The amount by which the lens is focused is constant, and it is fixed for the system.
(4) If a focusing error occurs, step drive cannot be controlled.
Control
Example
> FSTEPDRV=NEAR
< I:OK
Range acquisition
> RANGE FSTEPDRV
< r:FSTEPDRV=I, FAR, NEAR
SX50
Commands
supported ０１．００**
×
When a command is not supported, "e:0002 INVALID_COMMAND" is returned.
Supported Command States
Model Power supply
OFF ON PM D-RGB A-RGB1 A-RGB2 Comp
SX50
－ － － －
SX6
× ○ × ○
SX60
X600
*If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
*When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Meaning
This initiates focusing toward the far end.
This initiates focusing toward the near end.
RANGE command
.
"Error List."
ZCONTDRV command and FCONTDRV command.
SX6 SX60 X600
０１．０１** ０１．０１** ０１．０１**
○ ○ ○
Input
Video S-Video D-Video SCART
－ － － － －
○ ○ ○ ○ ○
Mode Control Setting
）
1-step control is exercised over the zoom toward the
NEAR end.
"FAR" or "NEAR" can be set for focus step control.
Mode
None Remote
－ － － －
○ ○ ○ ○
PAGE 67
９．Details of command FSTEPDRV
Reference
ＩＤ
Remarks
Local
－
×