Pre-Operation - Campbell Hausfeld IN470200AV Operating Instructions And Parts List Manual

Pre-Operation

uNPACKING
Remove the equipment and all parts from the carton . The
carton should contain the following:
• One pressure washer (pump, engine, cart base)
• One cart handle assembly
• One spray gun
• One lance
• One tip holder with 2 spray tips. Additional tips available
for purchase, see Page 13
• One high pressure hose
• One pack of nuts, bolts, and manuals
If any parts are missing, DO NOT reTurN THe uNIT TO THe
reTAILer. Know the unit's model number (located on the
serial number tag on the pressure washer frame) and call
1-800-330-0712 for replacement parts .
After unpacking the product, inspect it carefully for any
damage that may have occurred during transit . Make sure to
tighten fittings and bolts before using the pressure washer .
do not operate the unit if it's
damaged during shipping, handling,
or use. damage could result in bursting and cause injury or
property damage.
Brass
Thermal
Swivel
Relief
Adapter
Valve
Pump
Garden
Inlet
Hose
Figure 2 - Pump hook up
ASSeMBLY
1 . Slide the handle assembly over the lower legs of the cart
base . Use the supplied nuts and bolts to secure the handle
to the legs . See Figure 1 .
Figure 1 – Assemble Handle
2 . Brass Swivel Adaptor (See Figure 2) . If it's not already
attached to the pump inlet, assemble the brass swivel
adapter and attach it to the pump inlet (See Figure 3 and
Figure 4) . Be sure to connect the correct side of the brass
swivel adapter to the pump .
Chemical Injector
Hose Barb
High
Pump Pressure
Hose
Outlet
5
Pressure Washer
Connect This
End To Garden
Hose
Washer With
Filter Screen
Figure 3 - Brass swivel adapter
Brass Swivel
Adapter
Pump Inlet
Figure 4 - Connect the brass swivel to
the pump
www.chpower.com
Washer
Connect This
End To Pump