Configuration; Edid Configuration - Crestron DM-TX-4K-202-C Supplemental Manual

IR: 2-pin 3.5 mm detachable terminal block;

IR/serial port;
IR output up to 1.1 MHz;
1-way serial TTL/RS-232 (0-5 volts) up to 19200 baud
SETUP: (Applicable only to a configuration in which a DigitalMedia switcher is not

used) Red LED and recessed push button for Ethernet setup of the default static IP
address of the device
NOTE:
DM-TX-4K-202-C is 192.168.1.205.
RESET: Recessed push button for reboot of the device

For pin assignment information, refer to the Appendix on page 11.

Configuration

This section provides information about the following:
•
•
•

EDID Configuration

EDID (Extended Display Identification Data) configuration allows management of the EDID
that is to be sent to the upstream device connected to an HDMI input of the
DM-TX-4K-202-C or to an HDMI or VGA input of the DM-TX-4K-302-C. By default, the
EDID is set to DM default 4k 60Hz 2 ch for an HDMI input or to 01 DM default for a VGA
input. If a different EDID is desired, use DMTool to configure the EDID. An overview of the
steps necessary to configure the EDID is as follows:
NOTE:
1. Connect to the DM-TX-4K-202-C or DM-TX-4K-302-C.
2. Open the Setup window of the HDMI input for the DM-TX-4K-202-C or the Setup
3. In the EDID Configuration dialog box, configure the EDID by doing any of the
Supplemental Guide – DOC. 7932A
The default static IP address of the DM-TX-4K-302-C and the
EDID configuration
HDBaseT configuration
USB HID control configuration
For detailed information, refer to the Crestron Toolbox™ help file.
window of the HDMI or VGA input for the DM-TX-4K-302-C.
following:
Customize the current EDID.
o
Load an EDID template and modify it.
o
Create a new EDID file.
o
Load the existing EDID and modify it.
o
Obtain an EDID from the output and then save or customize it.
o
Apply an EDID that is saved on a computer.
o
DM-TX-4K-202-C/DM-TX-4K-302-C: 4K DigitalMedia 8G+ Transmitters • 5