Table of Contents
Advertisement
Configuration
This section provides information about the following:
EDID configuration
l
HDBaseT configuration
l
USB HID control configuration
l
EDID Configuration
EDID (Extended Display Identification Data) configuration allows management of the
EDID that is to be sent to the upstream device connected to an HDMI input of the DM-TX-
4K-202-C or to an HDMI or VGA input of the DM-TX-4K-302-C. By default, the EDID is set
to DM default 4k 60Hz 2 ch for an HDMI input or to 01 DM default for a VGA input. If a
different EDID is desired, use DMTool to configure the EDID. An overview of the steps
necessary to configure the EDID is as follows:
NOTE:
For detailed information, refer to the Crestron Toolbox™ software help file.
1. Connect to the DM-TX-4K-202-C or DM-TX-4K-302-C.
2. Open the Setup window of the HDMI input for the DM-TX-4K-202-C or the Setup
window of the HDMI or VGA input for the DM-TX-4K-302-C.
3. In the EDID Configuration dialog box, configure the EDID by doing any of the
following:
Customize the current EDID.
l
Load an EDID template and modify it.
l
Create a new EDID file.
l
Load the existing EDID and modify it.
l
Obtain an EDID from the output and then save or customize it.
l
Apply an EDID that is saved on a computer.
l
6 • DM-TX-4K-202-C and DM-TX-4K-302-C
Supplemental Guide — Doc. 7932B
Advertisement
Table of Contents
