Gateway 6010GZ Hardware Replacement Manual page 11

Replacing the Wireless
Network Card
Caution By law, only approved wireless modules provided
by Gateway, or a Gateway authorized
representative, explicitly for your notebook may
be installed in this notebook.
Tips & Tricks You need a small Phillips screwdriver to
replace the wireless network card.
Locating Components
Wireless
network
bay
Preventing static electricity discharge
The components inside your notebook are extremely
sensitive to static electricity, also known as electrostatic
discharge (ESD). ESD can permanently damage
electrostatic discharge-sensitive components in your
notebook.
Warning To avoid exposure to dangerous electrical
voltages and moving parts, turn off your
notebook, remove the battery, and unplug the
AC adapter, modem cable, and network cable
before replacing a component.
Warning To prevent risk of electric shock, do not insert any
object into the vent holes of your notebook.
Before working with notebook components, follow these
guidelines:
• Avoid static-causing surfaces such as carpeted floors,
plastic, and packing foam.
• Remove components from their antistatic bags only
when you are ready to use them. Do not lay
components on the outside of antistatic bags because
only the inside of the bags provide electrostatic
protection.
• Always hold components by their edges. Avoid
touching the edge connectors. Never slide
components over any surface.
• Wear a grounding wrist strap (available at most
electronics stores) and attach it to a bare metal part
of your workbench or other grounded connection.
• Touch a bare metal surface on your workbench or
other grounded object.
To replace the wireless network card:
1 Follow the guidelines under "Preventing static
electricity discharge."
2 Turn off your notebook.
3 Disconnect the AC adapter, modem cable, and
network cable.
4 Disconnect all peripheral devices and remove
any PC Cards.
5 Turn your notebook over so the bottom is
facing up, then remove the battery. For more
information, see "Changing Batteries" in your
user guide.
6 Loosen the wireless network bay cover screw
(this screw cannot be removed), then remove
wireless network bay cover.
Screw
www.gateway.com
Replacing the Wireless Network Card
1