Gateway 6010GZ Hardware Replacement Manual page 10

7 Loosen the six memory bay cover screws (these
screws cannot be removed), then remove the
memory bay cover.
8 If you are removing a memory module, gently
press outward on the clip at each end of the
module until the module tilts upward.
9 Pull the memory module out of the slot.
2
Screws
Screws
10 Hold the new or replacement module at a
30-degree angle and press it into the empty
memory slot. This module is keyed so it can
only be inserted in one direction. If the module
does not fit, make sure that the notch in the
module lines up with the tab in the memory
bay.
Important Use only memory modules designed for your
Gateway notebook.
11 Gently push the module down until it clicks in
place.
12 Replace the memory bay cover, then tighten
the cover screws.
13 Replace the keyboard screw.
14 Insert the battery, then turn your notebook
over.
15 Connect the power adapter, the modem cable,
and the network cable.
16 Turn on your notebook.
Technical Support
See the label on the bottom of the notebook for
Customer Care information.
Safety, Regulatory, and Legal
Information
See your user guide for important safety, regulatory, and
legal information.
© 2005 Gateway, Inc. All rights reserved. Gateway, Gateway
Country, the Gateway stylized logo, and the black-and-white
spot design are trademarks or registered trademarks of Gateway,
Inc. in the United States and other countries. All other brands
and product names are trademarks or registered trademarks of
their respective companies.
www.gateway.com
Replacing the Memory