Viessmann Vitocell 140-E Installation And Service Instructions Manual page 27

Cylinder with fitted Solar-Divicon
Fitting the cover strips
3.
C
A
B
Fig. 23 Shown: Vitocell 100-E, type SEIC, 600 l
Type plate
D
1. Tighten the nuts on the bolts.
2. Fit the front section of the Vitotrans thermal insula-
tion.
3. Prepare and fit the front cover strip in accordance
with the following table.
Preparing the front cover strip
Cylinder capacity
600 l
750 l
950 l
(cont.)
1.
2.
With Solar-Divicon only
Separate the cover strip at slot
B .
Separate the cover strip at slot
B . Trim part C , supplied with the connec-
tion set, to 300 mm, and use.
Separate the cover strip at slot
. Part , supplied with the connection
B C
set, can be used without being trimmed.
5.
4.
D
6.
4. Fit the rear cover strip to the thermal insulation.
5. Affix type plate .
D
6. Tap the thermal insulation towards the front. This
reduces the gap to the fitted modules.
With Vitotrans and Solar-Divicon
. Use part Do not use a cover strip.
A
. Use part Trim part
A
tion set, to 300 mm, and use.
A . Use part Part C , supplied with the connection set,
can be used without being trimmed.
Installation sequence
, supplied with the connec-
C
27