Stihl FS 70 Instruction Manual page 18

English
► Fit the thrust plate
► Turn the mowing head anticlockwise on the
shaft (1) as far as it will go
► Retain the shaft
► Tighten the mowing head
NOTICE
Remove the tool that was used to block the
shaft.
8.7 Removing the Mowing Head
► Retain the shaft
► Turn the mowing head clockwise
8.8 Fitting Mowing Head without
Screw Mounting
Keep the instruction leaflet for the mowing head
in a safe place.
18
1
8 Mounting the Cutting Attachment
8.8.1 STIHL FixCut 31-2
► Fit the thrust plate (2).
► Place the mowing head on the thrust plate (2).
WARNING
Collar (see arrows) must engage the mowing
head's mounting hole.
► Push the thrust washer (3) (convex side up)
over the shaft (1) until it is seated on the base.
► Block the shaft.
► Use the combination wrench (5) to screw the
mounting nut (4) onto the output shaft and it
tighten down firmly.
WARNING
If the mounting nut has become too loose, fit a
new one.
NOTICE
Remove the tool used to block the shaft.
8.9 Removing the Mowing Head
► Block the shaft.
► Use the combination wrench to loosen and
unscrew the mounting nut counterclockwise
from the output shaft.
0458-570-8321-B