Stihl FS 70 Instruction Manual page 14

English
► Fit the square nuts (3) in the barrier bar (6);
the holes must line up.
4
8
9
1
1
► Place the clamp (7) in the loop handle (4) and
position them both against the drive tube (8).
► Position the clamp (8) against the drive tube.
► Place the barrier bar (6) in position as shown.
► Line up the holes.
► Insert the screws (1) in the holes and screw
them into the barrier bar as far as stop.
► Go to "Adjusting and Securing the Loop Han‐
dle".
Leave the barrier bar permanently mounted to
the loop handle.
14
3
3
6
7
5 Mounting the Loop Handle
5.3 Adjusting and Securing the
Loop Handle
A
The loop handle can be adjusted to suit the
height and reach of the operator and the applica‐
tion by changing distance (A).
Recommendation: distance (A): about 15 cm
(5.9 in)
► Slide the handle to the required position.
► Line up the loop handle (4).
► Tighten down the screws until the loop handle
can no longer be rotated on the drive tube. If
no barrier bar is fitted – lock the nuts if neces‐
sary.
4
0458-570-8321-B