eMachines emonster Series User Manual page 71

5. Set the jumper of the new hard disk drive to CS (Cable Select).
6. Using the screws, secure the hard disk drive to the HDD bracket.
7. Connect the free power and hard disk drive cables to your hard disk drive.
8. Slide the drive until the four slots in the HDD bracket are inserted into the four tabs of the
chassis and then secure the HDD brakcet with the retaining screw, as shown below.
9. If you removed the hard disk drive cable from the mainboard, replace it.
10. Replace the system cover according to the instructions in "Replacing the Cover" in Chapter 5.
......................................................................................................................................................................................................................................
6-8
Installing and Removing Board Options and Drives
.........................................................................................................................................