AXIS Q1715 Block Camera
Additional settings
7. In the list of actions, under Recordings, select Record video while the rule is active.
8. Select a Camera.
9. Set the prebuffer time to 5 seconds.
10. Set the postbuffer time to 60 seconds.
11. Select where to save the recordings.
12. Click Save.
Set up the intrusion alarm
Before you start
•
Connect the intrusion alarm switch to pin 1 (ground) and pin 3 (digital I/O) of the camera's I/O connector.
Configure the input port
1. Go to Settings > System > I/O ports.
2. For Port 1:
2.1 Select Input in the drop-down menu
2.2 Select Closed circuit (NC) in the drop-down menu
Create a rule
1. Go to Settings > System > Events and add a rule.
2. Type a name for the rule.
3. In the list of conditions, under I/O, select Digital input.
4. In the list of ports, select Input 1.
5. In the list of actions, under Notifications, select Send notification to email.
6. Select a recipient from the list or go to Recipients to create a new recipient.
To create a new recipient, click
7. Type a subject and a message for the email.
8. Click Save.
Detect tampering with input signal
This example explains how to trigger an alarm when the input signal has been cut or short-circuited. For more information about the
I/O connector, see page 33.
. To copy an existing recipient, click
18
.
.
.