Bosch IXO Original Instructions Manual page 15

30 | English
If the battery charge indicator (4) lights up red when you press the on/off
switch (7) half way in, the remaining battery capacity is less than 30% and
the battery should be charged.
To charge the battery, plug the charging cable (13) into the port (12) on the
bottom of the handle and into the power supply (14). Plug the power supply
(14) into the plug socket.
The charging process is interrupted when the on/off switch (7) is fully
pressed.
The battery charge indicator (4) indicates the charging progress. The indic-
ator lights up in green during the charging process. When the battery is fully
charged, the battery charge indicator (4) goes out.
During the charging process, the handle of the power tool will become
warm. This is normal.
If you are not planning to use the power tool again soon, disconnect the
charger from the mains.
The power tool cannot be used during the charging process. It is not defect-
ive if it does not work during the charging process.
Protect the charger from moisture.
u
Follow the instructions on correct disposal.
Changing the tool (see figure B)
Do not use two-sided screwdriver blades that are longer than 25 mm.
u
Insert the screwdriver bit (1) directly into the tool holder (2).
Switching on the worklight (see figure C)
By turning the rubber cap (3), you can set the worklight (10) to focused or
diffused light as required. ➊ Remove the rubber cap by pulling it towards
you and ➋ place it back on the tool holder (2) with the appropriate lens.
Off-set Angle Adapter/Angle Screw Adapter/Torque Setting
Adapter (see figures C–F)
You can drive in screws close to edges using the off-set angle adapter (15).
The angle screw adapter (16) enables you to drive screws in hard-to-reach
areas.
1 609 92A 66B | (10.12.2020) Bosch Power Tools