General Installation Instructions - Taylor 358 Service Manual

https://appliancetechmanuals.com

General Installation Instructions

CAUTION: Only trained, authorized service
technicians should install this equipment. Failure to
comply will void the factory warranty.
The following are general installation instructions.
For complete installation details, please see the
checkout card.
ALL WIRING AND PLUMBING MUST
CONFORM TO NATIONAL AND LOCAL CODES.
INSTALL POTABLE WATER CONNECTION
WITH ADEQUATE BACK-FLOW
PROTECTION TO COMPLY WITH
APPLICABLE NATIONAL, STATE AND
LOCAL CODES.
Site Preparation
Review the area the unit is to be installed in before
uncrating the unit. Make sure that all possible
hazards to the user and the equipment have been
addressed.
Clearance: Air Cooled Units
Air cooled units require a minimum of 3" (76 mm) of
clearance around all sides of the unit. Failure to
allow for adequate clearance can reduce the
refrigeration capacity of the unit and possibly cause
damage to the compressor.
For Indoor Use Only: This unit is designed to
operate indoors, under normal ambient
temperatures of 70_ - 75_F (21_ - 24_C). The
machine has successfully performed in high ambient
temperatures of 104_(40_C) at reduced capacities.
This unit must NOT be installed in an area
where a water jet or hose can be used. NEVER use
a water jet or hose to rinse or clean this unit. Using a
water jet or hose on or around this equipment may
result in the electrocution of the user or damage to
the equipment.
Models 358 & 359
This unit must be installed on a level
surface to avoid the hazard of tipping. Extreme care
should be taken in moving this equipment for any
reason.
Two or more people are required to safely move this
unit. Failure to comply may result in personal injury
or equipment damage.
Uncrate the machine. Inspect the unit for damage.
Report any damage to the Taylor factory
immediately.
This piece of equipment is made in the USA and has
USA sizes of hardware. All metric conversions are
approximate and vary in size.
Installer Safety
In all areas of the world, equipment should
be installed in accordance with existing local codes.
Please contact your local authorities if you have any
questions.
Care should be taken to ensure that all basic safety
practices are followed during the installation and
servicing activities related to the installation and
service of Taylor equipment.
S Only authorized Taylor service personnel
should perform installation and repairs on
the equipment.
S
Authorized service personnel should consult
OSHA Standard 29CFRI910.147 or the
applicable code of the local area for the
industry standards on lockout/tagout
procedures before beginning any installation
or repairs.
S Authorized service personnel must ensure
that the proper PPE (Personal Protective
Equipment) is available and worn when
required during installation and service.
S
Authorized service personnel must remove
all metal jewelry, rings, and watches before
working on electrical equipment.
THIS UNIT HAS MANY SHARP EDGES
THAT CAN CAUSE SEVERE INJURIES.
7
Introduction