Advertisement
Handy Blending Tips
Blending Tips
• Do not operate for more than 10 minutes at
a time.
• Repeated use of the blender in a short
amount of time may result in error. Open
the blending Jug and check the contents.
Wait 30 seconds or unplug then plug in the
unit, then blend.
• Jug should be at least 25% full at all times
for optimal performance.
• Use High speeds as much as possible for
whole food juices, shakes, frozen mixtures,
making purées and nut butters. High speed
provides the best quality of refinement,
breaking down ice, frozen fruit, whole
fruits or vegetables to a smooth lump-free
consistency.
• Use only the amount of food suggested in
the recipes. If you want greater amounts,
prepare in batches. Using larger amounts
may overload and strain the motor.
• Use the PULSE button when mixture is
too thick or coarse to circulate within the
blender Jug.
• If on High speed the food is not circulating,
try using a spatula. If this is also not
working, try using a slower speed. Once
the food begins to circulate again, you can
switch back to a High speed.
• Due to the power of the machine, it is
normal for it to be fairly loud during
operation. Through the blending cycle, the
noises may change, but there is no need to
be concerned.
• Ice Crushing: For optimal ice crushing,
fill the Jug with preferred amount of ice.
Then fill with water just above where the
ice stops. Use the speed dial to blend on
High for a few seconds. Then drain out the
excess water and you are left with a Jug
filled with great consistent ice!
Add Ingredients While Blending
To add ingredients while blending,
remove the Filler Cap by turning it to the
Remove Cap position and lifting up. Add
in ingredients as desired, then put the
Filler Cap back into the Jug Lid and turn
it to the lock position.
Important: DO NOT BLEND HOT
LIQUIDS.
10
Frequently Asked Questions
Why doesn't the blender turn on?
• Make sure the Motor Base is plugged into
an active power receptacle.
• Verify the blinking blue light is active after
pushing the Power button.
• The Jug may not properly be placed into
the motor unit. When placed correctly
the Jug type will display on the screen. If
not displayed, ensure the jug is secured
properly to make contact with the sensor.
Why did the blender's timer reset?
• Check that the Sealing Ring is correctly
assembled in between the Blade and the
Jug.
Why did my blender stop blending?
• The blender is programmed to run a
maximum of seven continuous minutes
before stopping. If you need to blend
longer than seven minutes, wait 30
seconds before blending again.
• There may not be enough liquid in the
Jug to properly blend. If the Blender
senses this issue it will stop blending and
display a notifiction.
The Power and Start/Pause lights are
flashing
• The jug has been removed during
blending operation. Replace the jug and
restart the blending program.
11
Advertisement
