Advertisement
Blend-N-Go™ Bottle Accessory
1. Cup Lid
2. Break Resistant, BPA-Free Tritan™
Plastic Cup
3. Sealing Ring
4. 6-Point Blade
WARNING: The blade is very
sharp, handle carefully.
5. Threaded Jug Bottom
6. Motor Base
FOOD
MODE
HIGH
MED
THICKNESS
LOW
PULSE
4
Before Using Your ActiveSense™ Blender
Step 1. Remove Packaging
Ensure all packaging has been removed
carefully.
Important: : Always ensure your blender is
1
unplugged from the power outlet before fitting
or removing the Blade Assembly. Always
handle the Blade Assembly with caution, as the
blades are extremely sharp.
Note: When removing the Blade Assembly from
the Jug you may need to slightly tilt the blade
2
assembly so that it slides out easily.
Step 2. Wash and Dry Parts
Note: Before using your ActiveSense™ Blender,
we recommend removing the 6-Point Blade
Assembly for thorough cleaning. See page 7 for
more details.
1. Remove carefully the Blade Assembly
3
from the Tritan™ Jug by holding the Jug
upright and turning the Blade Assembly
clockwise.
4
2. Wash the parts listed below in warm
soapy water:
- Blade Assembly
- 1.7L blending Jug
5
- Jug Lid
- 750mL Blend-N-Go™ Bottle
- Cup Lid
3. Rinse and allow thorough air drying.
6
Step 3. Re-assemble the 6-Point Blade
Assembly in the Tritan™ Jug
Place carefully the Blade Assembly in the
Tritan™ Jug. Ensure that the Blade Assembly is
firmly in place by turning it anti-clockwise from
bottom of the Jug. The blender Jug will leak if
the 6-Point Blade Assembly is not assembled
correctly.
Step 4. Secure the Jug Lid and Filler Cap
Place the Jug Lid firmly onto the blending Jug.
Ensure the Filler Cap is tightly locked to avoid
movement during blending.
5
Advertisement
