Advertisement
Using Your Blend-N-Go™ Bottle
Note: Never blend hot liquids in the
Blend-N-Go™ Bottle.
1. Place the blade in the threaded Jug
bottom.
2. Place the Sealing Ring over the Blade
Assembly. Carefully press and tuck the
Sealing Ring into the locking groove. Refer
to page 7 for detailed instructions on
blade assembly.
3. Place all ingredients into the Bottle,
then tightly screw the Blade Assembly
clockwise into the Bottle.
4. Place the Bottle onto the Motor Base,
push down and turn anti-clockwise to
lock. The Bottle should be sitting evenly
on the 4 grooves of the Motor Base.
Placing The Cup Assembly
FOOD
MODE
HIGH
MED
5. Select the Food Mode and Thickness or
Manual Control (Low, Med, High) using
the Control Panel buttons. Press Start/
Pause Button to begin blending.
Note: The Food Mode Salsa option is not
available with the Blend-N-Go™ Bottle
accessory.
6. Press the Start/Pause button to stop
blending and the Power button to turn
the blender off. Remove the Bottle from
the Motor Base by applying downward
pressure and turning clockwise before
lifting up.
Removing The Cup Assembly
FOOD
MODE
HIGH
MED
8
Care And Cleaning
Cleaning
Caution: Blades are sharp. Handle
carefully.
• Empty the blending Jug. If necessary, use a
rubber spatula to scrape foods away from
the sides of the Jug.
• CAREFULLY remove the Blade Assembly
from the blending Jug by turning the Blade
Assembly counter-clockwise.
• All parts (except for the Motor Base)
are dishwasher safe. Use the top rack
of the dishwasher for the Filler Cap, Jar
Lid, Sealing Ring, Blade Assembly and
Threaded Jar Bottom. Place the blending
Jug into the bottom basket of dishwasher.
• The blending Jug, Jug Lid, Filler Cap,
Seal Selector Top, Cup Lid, Cup and Blade
Assembly can also be hand washed with
warm, soapy water. Rinse well and dry.
Note: It is recommended to hand wash the
Blade Assembly for longer usage.
• Check the parts as you put them back
together.
• Wipe the Motor Base with a soft, damp cloth
to clean. Never submerge the Motor Base in
a liquid.
Tip: Run the blender with soapy water for
20-30 seconds on Manual Mode of Low
or Med for cleaning without disassembly.
Follow with a clean water rinse.
Storing
• Reassemble the blender for storage. Leave
the Jug Lid open so no odors are retained.
Caution
: Never put the blending Jug, or
any other parts, in a microwave oven.
9
Advertisement
