Hitachi 46W500 Training page 149

DP-36 CHASSIS ADJUSTMENT SPECIFICATION CHANGES.
CORRECTION for DP-36 LOUD POP AT TURN ON WHEN ON ANTENNA C
(1) Enter Adjust Mode OSD
With Set Off, Press [POWER] and [INPUT] on the Control panel.
When High Voltage is Heard, release both buttons. Service Menu appears on screen.
POWER + Input
ADJUST MODE
SERVICE
SUB BRIGHT
WHITE BALANCE
G DRIVE(HIGH)
R DRIVE(HIGH)
R CUTOFF(HIGH)
G CUTOFF(HIGH)
B CUTOFF(HIGH)
H POSITION
V POSITION
FACT RESET
Thumbstick Down
nd
To 2 page.
ADJUST MODE
SUB CNT
OSD
AFC
MEMORY INT
I2C OPEN
P MODE ADJ
E2PROM edit
(3) EEPROM EDIT DATA CHANGES
Refer to ROM Correction Data Table on 2
Thumbstick down to locate only the addresses that have data shown in the table on the 2
page and make Data changes according to the Table for each address.
Press Select after each and every change in data value.
(4) ROM CORRECTION
After making all corrections to Data.
Exit the EEPROM Edit Menu by pressing EXIT button.
Exit the Service Menu by pressing the EXIT button.
Unplug set then reapply AC power to execute ROM CORRECTION.
(2) E2PROM Edit Mode is on the Adjust Mode 2
XXXXXX
**
**
**
**
**
**
**
Thumbstick down and Select
**
E2PROM edit
and Press The Thumbstick
Right → Button.
E2PROM Menu appears.
After making Data changes,
Press EXIT key to return to
main Service Menu.
•
Thumbstick down below FACT RESET to reveal
the 2nd page of the Service Menu.
•
Highlight E2PROM edit and press the Thumbstick
Right button to reveal the E2PROM edit menu.
•
Change Address by Thumbstick Up / Down but-
ton.
•
Change Data by Thumbstick Right / Left button.
•
Press SELECT button to set data after each and
every change.
•
Change Address by Thumbstick Up/Down button.
•
Change Data by Thumbstick Right/Left button.
•
Press SELECT button to set data after Each and
every change in Data.
E2PROM edit
nd
page
*Refer to Rom Correction Data Table on page 2.
ADDRESS
DATA
nd
page.
**
**
nd
Page 10-15