Hitachi 46W500 Training page 140

DP-3X THINGS YOUR SHOULD KNOW
Step (13) After Software upgrade/s have been successfully completed, please turn the power off. Then unplug the
AC power cord for 15 seconds
to reset the TV. Plug in the AC power cord and turn the TV on. Repeat steps 2 through 6 to check the software
version for verification.
Step (14) Your software version should now show
correct version number.
Step (15) To remove the MMC, gain access to the
rear of the set. Push the card in until a click is heard,
this will release the MMC and then remove the card.
NOTE: The MMC must be removed and returned to
Hitachi in order to receive any future upgrades.
IMPORTANT NOTE:
Are you aware that HDTV/SDTV Channels that are shown On Screen may not be the actual channel numbers
that you would press on the TV remote control to tune that specific channel?
In other words, what you see on the PTV Screen is called
(8-1) in San Diego (with out running auto programming in a DTV ) you will actually need to tune to channel 55.
Because UHF channel 55 is were they are receiving the Digital Virtual channel 8-1. The Virtual Channel infor-
mation is embedded within the data received is the Virtual Channel ID. This was decided because the Customer
will know that the HDTV channel they are watching will be a known channel in their area. This will help them to
recognize the channel of origin.
Below is an excellent web site to visit. This can be a tool that will help you KNOW what the actual channel is
when you are going to randomly select them by remote control number keys. You can just select it without a
need to run auto programming (on most units ~ with exception of the WXW prior to software upgrade).
http://www.transmitter.com DTV Channel Allocation for the whole USA...
(08) What to do if the DVD Door hangs or gets stuck on the DP-33W 46W500
•
If it's found that occasionally the DVD Door gets stuck and won't open. To fix this problem, ap-
ply a small felt like plastic piece on the door according to the location shown in the pictures be-
low. Part number for the SPACER is MN06355
•
See DVD Section To see how to remove the DVD Player.
Step 1:
Remove Speaker Grill, Front
Plastic piece and DVD plastic
housing.
Step 2:
Front of the DVD Tray. Front
Plastic Cabinet pieces re-
moved.
Continued on Next Page
VIRTUAL CHANNEL.
Figure 1
Setup
Upgrades
Software Version: Main
1394
MMC Software Upgrade
Upgrade Now
Please Insert MMC card
before upgrade
SEL
Move
As and example, to receive
V01.26
V01.06
Return
PAGE 10-06