Channel parameters
Each channel parameter block contains the cable parameters for the digital input (4 bytes).
The following figure shows the configuration of the channel parameters for channels 0 to 15.
x = 12 + (channel number * 4); with channel number 0...15
All unused bits and the bits or bytes marked as "reserved" must be set to zero.
You activate a channel parameter by setting the corresponding bit to "1" or the corresponding
value.
Figure A-3
DI 16x24VDC HA
Equipment Manual, 10/2020, A5E39265608-AD
Drivers, parameters, diagnostics messages and address space
A.2 Parameter assignment and structure of the module/channel parameters
Configuration byte x to x+3 for the channels 0 to 15
41