Parameter Reassignment; Explanation Of The Module/Channel Parameters; Diagnostics, Missing Supply Voltage L - Siemens SIMATIC ET 200SP HA Equipment Manual

Parameters

6.3 Explanation of the module/channel parameters

Parameter
Pulse stretching (Page 22)
Hardware interrupts positive
edge (Page 23)
2
Hardware interrupts nega‐
tive edge (Page 24)
2
Potential group (Page 24)
The wire break diagnostics can only be enabled when the "Check for wire break" parameter is enabled. If you use a simple
1
encoder contact, you need to connect a parallel resistor to enable wire break diagnostics in the open state (sensor resistance
for wire break diagnostics: 15 kΩ to 18 kΩ).
The input delay is switched off on all channels when high precision time stamping is activated. When high precision time
2
stamping is activated, pulse stretching and the rising/falling edge hardware interrupt are deactivated on all channels (not
adjustable).
6.2

Parameter reassignment

Definition
Each configuration change resets the corresponding reaction. Changing the configuration of a
function does not affect other functions.
6.3 Explanation of the module/channel parameters
6.3.1

Diagnostics, Missing supply voltage L+

Definition
Enabling of the diagnostics for missing or insufficient supply voltage L+.
20
Value range
2
• None
• 0.05 s
• 0.1 s
• 0.2 s
• 0.5 s
• 1 s
• 2 s
• Enabled
• Disabled
• Enabled
• Disabled
• Potential group of the left mod‐
ule (dark gray terminal block)
• New potential group (light gray
terminal block)
• No potential group (black termi‐
nal block)
Default Parameter re‐
assignment in
RUN
None Yes
Disabled Yes
Disabled Yes
Use potential No
group of the left
module
Equipment Manual, 10/2020, A5E39265608-AD
Efficiency range
Channel
Channel
Channel
Module
DI 16x24VDC HA