11.2.2 Faders; Encoders; 11.2.4 Buttons And Leds - PRESONUS FaderPort 16 Owner's Manual

11 Appendix
11.2 FaderPort Multichannel Controller MIDI Protocol

11.2.2 Faders

11.2.3

Encoders

11.2.4 Buttons and LEDs

Use MIDI pitch bend message to transmit fader moves and receive fader positions.
FaderPort 8. Channels 0-7 are used to address faders 1-8 respectively.
FaderPort 16. Channels 0-15 are used to address faders 1-16 respectively.
Faders
Transmitted
Fader index
Use CC messages to transmit increment and decrement values.
Transmitted endless rotary encoder delta values:
Pan / Param Encoder: B0, 10, xx
Session Navigator Encoder: B0, 3C, xx
xx delta value bit (Bit 6 = direction, Bits 0-5 = number of steps)
Buttons use Note On/Off messages to transmit the
pressed and released state on channel 0.
LEDs use Note On/Off messages to receive the on,
off and flashing state on channel 0.
Transmitted
Button press and release message
Received (On, Off, Flashing)
LED on / off message
Received (Color)
LED Color message
FaderPort™ Multichannel Production Controllers
Received Ex, ll, hh
Ex, ll, hh
x
Low 7 bits ll
High 7 bits hh
90, id, ss
ID See ID Table
ss State (Release: 00, Pressed, 7F)
90, id, ss
ID See ID Table
ss State (Off: 00, On: 7F, Flashing: 01)
MIDI channel 1-3 is used to set the RGB values of a LED
color with 7-bit resolution per color
Red 91, id, cc
Green 92, id, cc
Blue 93, id, cc
ID See ID table
cc 7-bit color value
Owner's Manual
80