Stihl MS 210 Instruction Manual page 31

20 Starting / Stopping the Engine
20.8 As soon as the engine runs
0
3
► Press down trigger lockout and the blip the
throttle trigger (4) – the Master Control
lever (3) moves to the run position (F) and the
engine settles down to idling speed.
0458-208-0121-C
5
4
NOTICE
As the chain brake is still engaged, the engine
must be returned to idling speed immediately –
or the engine housing and chain brake might oth‐
erwise be damaged.
► Pull the hand guard back toward the front han‐
dle.
The chain brake is now disengaged – your saw is
ready for operation.
NOTICE
Always disengage chain brake before accelerat‐
ing the engine. High revs with the chain brake
engaged (chain locked) will quickly damage the
clutch and chain brake.
20.9 At very low outside tempera‐
tures
► Allow engine to warm up at part throttle.
20.10 Shut off the engine.
► Move the Master Control lever to the stop
position (0).
20.11 If engine does not start
If you did not move the Master Control lever from
the choke closed position (l) to the starting
throttle position (n) quickly enough after the
English
31