Cutting Attachment; Mounting The Bar And Chain (Side Chain Ten- Sioner) - Stihl MS 210 Instruction Manual

5 Cutting Attachment

► Tip of the guide bar must penetrate the wood
before the holding strap (4) – guide the chain‐
saw absolutely horizontally and swivel as
widely as possible
► Make the felling cut up to the hinge (5)
– Do not cut into the hinge
► Make the felling cut up to the holding strap (6)
– Do not cut into the holding strap.
Shout a second warning immediately before the
tree falls.
► With outstretched arms, cut through the hold‐
ing strap at a downward angle from outside.
5 Cutting Attachment
A cutting attachment consists of the saw chain,
guide bar and chain sprocket.
The cutting attachment that comes standard is
designed to exactly match the chain saw.
1
a
– The pitch (t) of the saw chain (1), chain
sprocket and the nose sprocket of the Rollo‐
matic guide bar must match.
– The drive link gauge (2) of the saw chain (1)
must match the groove width of the guide
bar (3).
If non-matching components are used, the cut‐
ting attachment may be damaged beyond repair
after a short period of operation.
0458-208-0121-C
5.1 Chain Scabbard
Your saw comes standard with a chain scabbard
that matches the cutting attachment.
If guide bars of different lengths are mounted to
the saw, always use a chain scabbard of the cor‐
rect length which covers the complete guide bar.
The length of the matching guide bars is marked
on the side of the chain scabbard.
6 Mounting the Bar and
Chain (side chain ten‐
sioner)
6.1 Removing the chain sprocket
cover
2
3
► Unscrew the nuts and take off the chain
sprocket cover.
English
1
2
15