Stihl MS 210 Instruction Manual page 24

English
14.4.3 Closing
Bracket is in an upright position:
► Position filler cap – markings on filler cap and
fuel tank must align
► Push the filler cap down as far as it will go
► Hold the filler cap down and turn it clockwise
until it engages
Then the markings on filler cap and fuel tank will
align
► Close bracket lock
24
Filler cap is locked
14.4.4 If the filler cap will not lock onto the
fuel tank
The base of the filler cap is twisted in relation to
the upper part.
► Remove the filler cap from the fuel tank and
look at it from above
left: Base of filler cap is twisted – interior
marking (1) is aligned with the exte‐
rior marking
right: Base of filler cap is in the correct
position – interior marking is below
the bracket. It does not align with
the exterior marking
► Fit filler cap and turn it counterclockwise until it
engages in the seat of the filling port
► Continue to turn the filler cap counterclockwise
(approx. 1/4 turn) – this will twist the base of
the cap into the correct position
14 Fueling
1
0458-208-0121-C