RIDGID BS1400 Owner's Manual page 16

Assembly (continued)
3. Place stand top upside down on a level
surface. Fasten four legs to top using
carriage bolts, washers, lock washers,
and nuts, as shown. Note: Legs fasten
to outside of top. Do not tighten at this
time.
4. Fasten two long stiffeners and two
short stiffeners to stand legs using car-
riage bolts, washers, lockwashers, and
nuts, as shown. Finger tighten only at
this time.
5. Turn assembly over onto the legs. Be
sure all four feet sit flat on the ground.
Adjustment of the feet will be com-
pleted after the band saw is attached to
the stand.
6. Tighten all stand fasteners at this time.
7. With the aid of a second person, lift the
saw body out of the shipping container
and place onto the stand top. Be sure
front of saw faces stand front by align-
ing holes.
CAUTION: Saw body is heavy!
Use care when lifting and stabi-
lize until it is firmly attached to
the stand! Get help when lifting
and mounting saw.
M8
Washer
Carriage
Bolt
Leg
Stand Top
16
M8
Lockwasher
M8 Nut
Stiffener
Stiffener
(Short)
(Long)