Table of Contents
Advertisement
6.2.
Programming
6.2.1. Programming Display and Programming Menu
Ensure that you have fully understood the meaning of the terms used in the
following information and instructions.
A display is installed on the electronic board of the station which displays the
programming menu for all the station functions and provides automatic operating
instructions and management instructions for the connected weather sensors.
All the settings of the PXXX functional parameters must be made through the keys and
display of the station, changing the preset values F [factory-set].
→ The OK key is used to enter the programming menu and confirm the setting of each
individual parameter.
→ The + (plus) key is used to scroll up through the programming menu or increase the
value of the parameter within the menu.
→ The – (minus) key is used to scroll down through the programming menu or decrease
the value of the parameter within the menu.
→ The + (plus) and – (minus) keys pressed together are used to exit the programming
menu.
The initial menu is free of any writing when no input is active; otherwise it
shows the activated function with the following messages:
(display)
Pressing + (plus) and – (minus) together displays the total number of
channels of the PIK radio remote control saved in the memory.
- In01 - general Open
- In02 - general Close
- In11 - motor 1 Open
- In12 - motor 1 Close
- In21 - motor 2 Open
- In22 - motor 2 Close
- In31 - motor 3 Open
- In32 - motor 3 Close
- In41 - motor 4 Open
- In42 - motor 4 Close
- In51 - motor 5 Open
- In52 - motor 5 Close
- In61 - motor 6 Open
- In62 - motor 6 Close
- pk01 - channel 01 of the PIK radio remote control
- u Km - wind speed
- r
- rain state
- cron
- timed thermostat / timer
Page 8
Advertisement
Table of Contents
