Table of Contents
Advertisement
Repairs should only be performed by qualified personnel at assistance centres
authorised by the manufacturer.
In the event of any problems or queries, consult your agent or contact the
manufacturer directly.
Always request exclusive use of original spare parts. Failure to respect this
condition could compromise safety and invalidate the benefits contained in the
warranty for the appliance.
The product must be disposed of in compliance with local environmental
regulations and not as household waste.
2. CONSTRUCTION AND REGULATORY REFERENCES
This product was designed to be used with products suitably studied for the
specific application. If assembled incorrectly, use of the product with other
devices may result in damage or malfunctions.
The power supply system and electrical connection must comply with EU
standards for electrical systems.
The equipment has double electrical insulation and thus does not
require an earth wire. All devices connected to the station must be
earthed by the installer unless equipped with double insulation.
The stations are constructed according to European Union directives and
certified in conformity with the
control units must be manufactured according to current regulations and in
compliance with EC standards.
3. TECHNICAL DATA
Model
Power supply voltage of the
station
Output voltage
Maximum switchable output
current per motor
Maximum power absorbed by
the station
Service type
Double electrical insulation
Setup for connection to
external devices
Operating temperature
Degree of protection
The data provided in these illustrations is non-binding and subject to change, even without advance notice.
mark. All the devices connected to the
1120.30
1120.31
230 V~ (±10%) 50 Hz
1 A
(2.5 A Fuse per module)
75W
S1
NO
Wind sensor - Rain sensor - Daily timer
- General open-close command
-5 ÷ +60 ºC
IP43
Page 5
1120.32
1120.34
1120.33
1120.35
24V = dc
100W
150W
Advertisement
Table of Contents
