Margin - Canon iR3300 Series Printer Manual

Margin

3
3-8 Settings Menu
-30.0 - 0.0 - +30.0 mm (in increments of 0.5 mm)
This setting sets the page margin in mm. The settings can be set between
-30.0 mm (-1.20 inch) to +30.0 mm (+1.20 inch) in increments of 0.5 mm
(0.01 inch).
Use [ ] to increase the width of the inside margin. Use [
increase the size of the outside margin.
[0mm]
Center
You can specify the edge along which the margin will be created in the
Binding setting (previous setting.) To create a margin along one of the
edges of the paper, use this setting in combination with the Binding setting.
IMPORTANT
• If this setting moves the image outside the printable area,
part of the image may be cut off.
NOTE
• If this setting is used in combination with the Offset X/
Offset Y setting, the two settings are added together.
• Pressing [
(0.01 inch) each time the key is pressed. Pressing [
decreases the value by 0.5 mm (0.01 inch) each time.
Holding down either [
up the value alteration.
[ - ]
[ + ]
Center Center
] increases the setting value by 0.5 mm
] or [ ] continuously speeds
] to
]