Installing Power Connector Port; Led Board; Removing Led Board - Dell Latitude 7380 Owner's Manual

Installing power connector port

1. Install the power connector port into the slot on the computer.
2. Place the metal bracket on the power connector port.
3. Tighten the M2.0x3.0 screw to secure the power connector port to the computer.
4. Connect the power connector port cable to the connector on the system board.
5. Install the base cover.
6. Follow the procedure in

LED board

Removing LED board

1. Follow the procedure in
2. Disconnect the battery cable from the connector on the system board.
3. To remove the LED board:
a. Disconnect the LED cable from the LED board [1].
CAUTION: Avoid pulling the cable as it would result in breaking the cable connector. Instead, use a scribe
to release the LED cable from its connector.
b. Unroute the LED cable from the routing channel [2].
c. Remove the M2.0 x 2.5 screw that secures the LED board to the computer [3].
d. Lift the LED board from the computer [4].
After working inside your
Before working inside your
computer.
computer.
Disassembly and reassembly 27