3. Disconnect the battery cable from the connector on the system board.
4. To remove the power connector port:
a. Disconnect the power connector port cable from the system board [1].
Use a plastic scribe to release the cable from the connector. Do not pull the cable as it may result in
NOTE:
breakage.
b. Remove the M2.0 x 3.0 screw to release the metal bracket on the power connector port [2].
c. Lift the metal bracket from the system [3].
d. Remove the power connector port from the computer [4].
Installing power connector port
1. Install the power connector port into the slot on the system.
2. Place the metal bracket on the power connector port.
3. Replace the M2.0 x 3.0 screw to secure the power connector port to the system.
4. Connect the power connector port cable to the connector on the system board.
5. Connect the battery cable to the connector on the system board.
6. Install the
base
cover.
7. Follow the procedure in
Display Assembly
Removing display assembly
1. Follow the procedure in
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
29