Installing LED board
1. Insert the LED board into the slot on the computer.
2. Tighten the M2.0 x 2.5 screw to secure the LED board.
3. Route the LED cable through the routing channel.
4. Connect the LED cable to the system board.
5. Connect the battery cable to the connector on the system board.
6. Follow the procedure in
Smart card module
Removing smart card cage
1. Follow the procedure in
2. Remove the
base
cover.
3. Disconnect the battery cable from the connector on the system board.
4. Remove the
PCIe SSD card
5. To disconnect the smart card cable:
a. Disconnect the smart card cable [1].
NOTE:
Ensure to gently push the connector, to avoid damage to the smart card head.
b. Lift the smart card cable that is affixed to the touchpad module [2].
NOTE:
Ensure to pull gently to release it with adhesive tape.
6. To remove the smart card cage:
a. Remove the M2 x 3 screws (2) that secure the smart card cage to the computer [1].
28
Disassembly and reassembly
After working inside your
Before working inside your
.
computer.
computer.