Adjustment
1
Position of the thread catcher
.07 .04
● Move thread catcher 1 (screws 2, two screws) in accordance with requirement 1.
● Turn thread catcher 1 (screw 3) in accordance with requirement 2.
44
Requirement
1. The bottom edge of the thread catcher 1 should be at a distance of 0.1 mm from the
positioning fi nger of the bobbin case 5.
2. When the thread trimmer is in its neutral position, the rear edge of thread catcher
should be positioned approx. 2.5 - 3 mm behind the edge of the knife.
0,1 mm
5
3
Fig. 1 - 35
Thread catcher 1 must be parallel to the surface of the thread catcher holder 4.
5
1
1
4
2