Table of Contents
Advertisement
1
Roller-presser
.05.17
Requirement
When the roller-presser 1 is resting on the feed wheel 6 it must
1. be parallel to the feed wheel 6 when viewed in the direction of sewing,
2. be in the middle of the (needle when viewed in the direction of sewing and
3. be as close as possible to the needle when viewed in transverse direction of sewing.
1
Fig. 1 - 16
● Raise the roller-presser 1.
● Place roller-presser bracket 2 (screws 3) fl ush to the bottom edge of presser bar 4.
● Always observe requirement 1 when carrying out the following adjustments.
● Move the roller-presser 1 ( screw 5 ) in accordance with requirement 2.
● Allow the roller-presser 1 to come to rest on the feed wheel 6.
● Move bracket 7 (screw 8) according to requirement 3.
8
7
When sewing very tight curves the roller-presser 1 should be moved toward
the operator slightly.
Adjustment
4
5
6
3
2
25
Advertisement
Table of Contents
