Table of Contents
Advertisement
1
Roller-presser
.05.10
Requirement
When the roller-presser 1 is resting on the feed wheel 6 it must
1.
be parallel to the feed wheel
2.
be in the middle of the (needle when viewed in the direction of sewing and
3.
be as close as possible to the needle when viewed in transverse direction of sewing.
1
Fig. 1 - 10
●
Raise the roller-presser
●
Place roller-presser bracket
●
Always observe
●
Move the roller-presser
●
Allow the roller-presser
●
Move bracket
6 when viewed in the direction of sewing,
8
7
1.
2 (screws 3) fl ush to the bottom edge of presser bar 4.
requirement 1 when carrying out the following adjustments.
1 ( screw 5 ) in accordance with requirement 2.
1 to come to rest on the feed wheel 6.
7 (screw 8) according to requirement 3.
When sewing very tight curves the roller-presser 1 should be moved toward
the operator slightly.
Adjustment
4
5
6
3
2
17
Advertisement
Table of Contents
