Table of Contents
Advertisement
Adjustment
1
Needle position in the direction of sewing
.05.03
●
●
●
●
●
●
8
Requirement
With the stitch length set at "5", in its front and rear point of reversal the needle should be
the same distance from the inside edges of the needle hole.
Fig. 1 - 03
Turn on machine and set stitch length to "
Turn machine off and on (synchronise needle bar to stitch length).
Sew a stitch and check the rear position of the needle according to the requirement.
Press the stitch control key, sew a stitch and check the forward position of the needle ac-
cording to the requirement and where necessary make the following adjustments.
Turn off machine and loosen screws
Push the adjusting pin's angled part (Order No.
into the hole in lever 4.
4
3
2
5".
1 and 2.
61-111Snnb641-48 through hole 3
1
5
Advertisement
Table of Contents
