Sectional Views; Mechanical Function - Panasonic KV-S2065L Service Manual

4. Press the MODE Key [
To active the SCSI ID settings, press the HOME Key to return to
"READY", then turn the unit off and on.
5. Press the SELECT [
setting.
The [ ] Key moves to the next content as shown below.
The [ ] Key moves to the previous content.
Note:
- If the scanner is the last device in the SCSI chain, then the
terminator should be set to "Enable". But, under the above SCSI
chain and scanner's turn-off, the terminator should be attached to
the SCSI connector on the scanner.
- Setting the SCSI ID will be activated after turning the power OFF
and turning it ON again.
- Setting the terminator will be activated after turning the power OFF
and turning it ON again.

5. SECTIONAL VIEWS

5.1. Image Sensors, Motors and Imprinters (Option)
5.2. Rollers
5.3. Circuit Boards
5.4. Sensor Boards and Switches

6. MECHANICAL FUNCTION

6.1. Paper Feed Mechanism
] to switch to the terminator setting.
] Key or [ ] Key to select the desired
12