Complete The Finished Wall/Deck; Complete The Concrete Installation; Clean-Up After Installation - Kohler K-1394 Installation Manual

Round bath whirlpool
Hide thumbs Also See for K-1394:
Table of Contents

Advertisement

Available languages

Available languages

9. Complete the Finished Wall/Deck

If you have not already done so, carefully remove the protective tape from the whirlpool rim.
Cover the framing with water-resistant wall material. Seal the joints between the whirlpool rim edge
and the water-resistant wall material with silicone sealant.
Tape and mud the water-resistant wall material. Install the finished wall to the water-resistant wall
material so it is 1/16" (2 mm) above the enameled surface. Seal the joints between the whirlpool rim
and the finished wall material with silicone sealant.
Install the faucet trim according to the instructions packed with the trim.

10. Complete the Concrete Installation

If you have not already done so, carefully remove the protective tape from the whirlpool rim.
Apply mortar and tile to the wall, deck and surround material as needed.
Apply a bead of sealant where the tile meets the whirlpool surface.
Install the faucet trim according to the instructions packed with the trim.

11. Clean-Up After Installation

When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the
whirlpool surface. If necessary, use warm water and a liquid detergent to clean the surface of the
whirlpool, user keypad and remote control.
Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners
containing petroleum distillates to remain in contact with any whirlpool surfaces for long periods
of time. Remove plaster by carefully scraping with a wood edge. Do not use metal scrapers, wire
brushes, or other metal tools. Use a powder-type detergent on a damp cloth to provide mild
abrasive action to any residual plaster.
1022205-2-B
Apply silicone sealant to the water-resistant
wall material and the finished wall.
Whirlpool
Drop-In Installation
Apply silicone sealant to the water-resistant
wall material and the finished wall.
Whirlpool
Flush Installation
Install the finished
wall material.
First install water-
resistant wall material.
Install the finished wall
material.
First install water-
resistant wall material.
10
Kohler Co.

Advertisement

Table of Contents
loading

This manual is also suitable for:

K-1397K-1399

Table of Contents