Setting Up; Using The Appliance For The First Time - SEVERIN Wurster WT 5005 Instructions For Use Manual

4 Setting up

The appliance should be set up on a suitable worktop meeting following
requirements:
•
near an earthed safety socket (minimum fuse protection 10 A),
•
level, stable and shock-resistant,
•
heat-proof and unaffected by the rubber coating of the feet,
• well away from any heated or inflammable surfaces and objects
(minimum 1 m or more)
•
well away from walls (minimum 1 m or more)
WARNING!
Fire hazard – The heat radiating from the appliance
is sufficiently strong to ignite flammable objects
nearby.
– A minimum clearance of 1 metre or more from
any appliance, overhang, ceiling or other object
must be maintained.
5 Using the appliance for the first time
Before you use the appliance for the first time, is must be operated once wit-
hout any sausages inserted; this will eliminate of any odour typically emitted
when switching on appliances of this type for the first time:
1. Set up the unit as described in Chapter 4 ‚Setting up'.
2. Completely remove any packaging materials and stickers from on and
inside the appliance. Pull the grill insert together with the reflectors
upwards and out of the appliance (see 9.2, point 2., Fig. 4 on page 34).
WT5005_CS6VM_EN.indd 29
Open and take off the cleaning flap (see 9.3 ‚After use: cleaning the
interior' on page 36). Remove all cardboard and polyfoam inlays from
the interior of the appliance.
3. Re-insert the grill insert (see 9.2, point 10, Fig. 9 on page 17).
Insert the separately enclosed sausage holder (No. 13) (see 9.3, point
10, Fig. 10b on pages 36/37)
4. Insert the plug into a suitable safety wall socket.
5. Select the 'thick sausage' programme, using the „ " button.
 The selected button lights up.
6. Push the slide control all the way down until it locks into place.
HINT:
Press down the slide control and hold for 0.5 seconds
until it clicks into place and the countdown or the
animated image „pre-heating phase" starts.
 Pre-heating starts.
 During this phase, the display shows an animated picture.
 Once pre-heating is complete, the display shows the remaining
grilling time, counting down.
HINT:
During the first few heating cycles, the appliance
may emit a slight smell and a little smoke. This is
harmless and will disappear after a short while.
Ensure adequate ventilation.
7. Wait until the grilling cycle has finished, when the slide control comes
up again.
8. Let the appliance cool for 2 minutes before starting the next grilling cycle.
GB
29
21.08.2020 11:01:15