Table of Contents
Advertisement
User Guide
Viewing the amount of memory
To view the amount of memory, proceed as follows:
1
Turn on the computer.
2
Click the Start button, point to All Programs, Security & Utilities, then VAIO System Information, and click VAIO System
Information again.
You can view the amount of installed memory here.
Adding / replacing a memory module
If you are not familiar with upgrading memory on a computer, we highly recommend that you contact your dealer.
To add or change a memory module, proceed as follows:
1
Shut down the computer, unplug it, and remove any peripheral devices.
2
Wait for the computer to cool down.
The inside of the main unit becomes very hot during operation. Wait for about one hour for
the computer to cool down before opening the unit.
3
With the main unit's back panel facing you, locate the 2 screws holding the left panel, and
unscrew them. Pull the panel towards using the hole located between the 2 screws.
4
Set the cover aside and lay the unit on it's side.
5
In the middle of the unit, you will notice a frame which is held by 2 screws. The memory slots
can be seen below this frame. Remove the 2 screws, and pull the frame upward by the 2
clips which hold it in place.
✍
Picture may vary from actual configuration.
n N
58
Upgrading your VAIO computer
Advertisement
Table of Contents
