Page 3
Getting Started Thanks for choosing Dual. This manual is designed to provide information for the purchaser of Dual car audio products. Dual has attempted to make sure all the information in this manual is current. But, this information is subject to change without notice.
Parts of the following instructions will not apply to your installation. The installation instructions included here are basic. If you feel unsure about personally installing the speaker system. Dual recommends that you seek installation by a qualified auto sound technician.
Page 5
XS SERIES INSTALLATION Mounting Standard Rear Deck Installation 1. Determine where the speakers will be mounted. Ensure an area large enough for the speaker to mount grille evenly. Be sure that the mounting location is deep enough for the speaker to fit 2.
Page 6
XS SERIES INSTALLATION Mounting TWEETER PROTRUSION MOUNTING HEIGHT CUT-OUT DIAMETER TOP-MOUNTING DEPTH BOTTOM-MOUNTING DEPTH The diagram featured above is to be used in conjunction with the specifications matrix guide found on the following page.
Page 8
What to do? If the product requires warranty state to state. service, you must prepay the initial shipping charges. DUAL will pay the return shipping Namsung America Inc. warrants this product to charges if the product is returned to an address the original purchaser to be free from defects in within the USA.
Page 10
XD5200 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. (consult a qualified technician for instructions) • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
XD5200 OPERATION General Operation Faceplate Removal Press REL and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure. *For semi-permanent faceplate installation, remove trim ring and install supplied Phillips head #1 screw through left side of mounting frame into faceplate.
Page 15
XD5200 OPERATION General Operation Reset Press and hold for more than 2 seconds to RESET the unit upon initial installation. The RESET button is located behind the faceplate. Audio Press AUD to select between Volume (default), Bass, Treble, Balance & Fader. Bass Press AUD until BA appears Press VOLUME...
XD5200 OPERATION Tuner Operation Seek Tuning Press TUNE momentarily to seek the next strong station. Manual Tuning Press TUNE for more than 2 seconds, then press TUNE momentarily to move radio frequency up or down one step at a time. Press and hold to advance quickly.
XD5200 OPERATION CD Player Operation With the label facing up, insert a standard 5" CD into Insert CD the CD slot. The CD will automatically begin playback. Press the EJECT button to stop and eject the CD. The Eject CD unit will change to tuner mode.
What to do? If the product requires warranty service, you must prepay the initial shipping Namsung America agrees, at our option, during charges. DUAL will pay the return shipping the warranty period, to repair any defect in charges if the product is returned to an address material or workmanship or to furnish an equal within the USA.