Table of Contents
Advertisement
Min Saving
Max Saving
HDD Power Down
When enabled and after setting time of system inactivity, the hard disk drive will be powered
down while all the other devices remain active.
The settings are: 1/2/3/4/5/6/7/8/9/10/11/12/13/14/15 Min and Disabled.
Suspend Mode
When enabled and after the set time of system inactivity, all devices except the CPU will be
shut off.
The settings are: l/2/4/8/12/20/30/40 Min, 1 Hour, and Disabled.
Video Off Option
This determines the manner in which the monitor is blanked. The choice are Suspend off,
All Modes Off, and Always On.
Video Off Method
This determines the manner in which the monitor is blanked.
DPMS (default)
Blank Screen
V/H SYNC+Blank
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
Soft-off by PWR-BTTN
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off
state. The settings are: Delay 4 Sec, Instant-Off.
Wake Up by PCI card
This will enable the system to wake up to PCI Lan Card.
The settings are: Enabled and Disabled.
Power On by Ring
During Disabled, the system will ignore any incoming call from the modem. During Enabled,
the system will boot up if there's an incoming call from the modem.
CPU Thermal-Throttling
Select the CPU THRM-Throttling rate. The settings are: 12.5%, 25.0%, 37.5%, 50.0%,
62.5%, 75.0%, 87.5%.
Resume by Alarm
This function is for setting date and time for your computer to boot up. During Disabled, you
cannot use this function. During Enabled, choose the Date and Time Alarm:
Date(of month) Alarm
You can choose which month the system will boot up. Set to 0, to boot every day.
of the ranges is from 1 min. to 1hr. except for HDD Power Down
that ranges from 1 min. to 15 min. and disable.
Minimum power management. Doze Mode 1H, Suspend Mode=1 hr.,
Power Down=15 min.
Maximum power management. Doze Mode 1H, Suspend Mode=1
min., Power Down=1 min.
Initial display power management signaling.
This option only writes blanks to the video buffer.
This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video
buffer.
33
Advertisement
Table of Contents
