Table of Contents
Advertisement
®
TROUBLESHOOTING
PROBLEM
Nothing happens; fan does not move.
Note: Replace with battery type
23A, MN-21 or equivalent. See STEP
9 - REMOTE CONTROL.
Noisy operation.
24
All manuals and user guides at all-guides.com
PROBABLE CAUSE
1. Power turned off, fuse blown, or
circuit breaker tripped.
2. Loose wire connections or wrong
connections.
3. Remote battery weak or not in-
stalled properly.
4. Dip Switches not set.
5. Fan remote receiver defective.
1. Blade screwed loosely to blade iron.
2. Blade cracked.
3. Using non-approved speed control.
4. Globe is not properly installed.
SOLUTION
1. Turn power on, replace fuse, or re-
set breaker.
2. Loosen canopy, check all connec-
tions according to STEP 4 - WIRING
THE FAN (turn power off be-
fore checking).
3. Install fresh Alkaline battery. See
STEP 9 - REMOTE CONTROL.
4. See STEP 9 - REMOTE CONTROL.
5. Replace receiver.
1. Tighten screws until snug.
2. Replace all blades.
3. Change to approved speed control.
4. Refer to the Globe Installation sec-
tion.
41467-01 8/14/2001
Advertisement
Table of Contents
