Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Hunter 28198
Summary of Contents for Hunter 28198
- Page 1 © 2005 Hunter Fan Company 41857-01 02/22/2005...
-
Page 2: Cautions And Warnings
If you need help installing the fan, your Hunter fan dealer can di- rect you to a licensed installer or electrician. ® gathering the tools Your new Hunter ® ceiling fan is an addition to your home or office You will need the following tools for installing the fan: that will provide comfort and performance for many years. -
Page 3: Preparing The Fan Site
Figure 5 - Adequate existing fan site to Floor If your existing fan site is suitable, go to the installing the ceiling plate section and begin installing your new Hunter fan. preparing a new fan site Figure 4 - Minimum mounting distances To prepare the fan site follow four steps: •... -
Page 4: Installing The Ceiling Plate
Refer to Figure 9. Support Brace Isolators Washer Outlet Box 1/16” Recess Ceiling Plate Wood Screw Figure 9 - Inserting the isolators into the ceiling plate Figure 7 - Installing the outlet box 41857-01 02/22/2005 © 2005 Hunter Fan Company... -
Page 5: Assembling The Fan
Once assembled, do not remove the downrod. completely tighten as to keep the hook from being able to swing. Continue to the hanging the fan section. © 2005 Hunter Fan Company 41857-01 02/22/2005... -
Page 6: Hanging The Fan
Refer to Figure 19. ible after making connections. All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70. If you are unfamiliar with wiring, you should use a qualified electrician. 41857-01 02/22/2005 © 2005 Hunter Fan Company... -
Page 7: Assembling The Blades
Tab Hole assembling the blades and Tab Hunter fans use several styles of fan blade irons (brackets that hold Canopy the blade to the fan). Screw Your fan may include blade grommets. If your fan has grom- mets, insert them by hand into the holes on the blades as shown in Figure 22. -
Page 8: Setting Up The Remote
Note: Any changes or modifications to the transmitter or receiver not expressly approved by Hunter Fan Company may void one’s authority to operate this remote control. Your fan is equipped to be operated by remote control. A receiver device is mounted inside the fan switch housing. -
Page 9: Installing The Switch Housing
CAUTION: Make sure the upper switch housing is se- curely attached to the switch housing mounting plate. Fail- ure to properly attach and tighten all three housing assem- bly screws could result in the switch housing and light fix- ture falling. © 2005 Hunter Fan Company 41857-01 02/22/2005... -
Page 10: Operating Your Ceiling Fan
Press the REVERSE button to change the fan’s direc- tion while the fan is running. NOTE: Replace 12-volt battery with type 23 A, MN-21 or equiva- lent. Reverse Fan High Fan Medium Fan Low Fan Off Figure 32 - Remote operation 41857-01 02/22/2005 © 2005 Hunter Fan Company... -
Page 11: Troubleshooting
Select a fan speed button to start fan, then press the re- verse button. If you need parts or service assistance, please call 888-830-1326 or visit us at our WEB site at http://www.hunterfan.com. Hunter Fan Company 2500 Frisco Avenue Memphis, Tennessee 38114 © 2005 Hunter Fan Company 41857-01 02/22/2005...