Using Auto Memory Store (Ams) - Radio Shack HTX-242 Owner's Manual

All manuals and user guides at all-guides.com
7. Press
subaudible tone.
8. Rotate
change the receive subaudible tone.
9. Press
subaudible tone.
10. Rotate
change the transmit subaudible tone.
11. For the calling-frequency memory, press
settings.
For a standard memory, press
Sn
select whether the memory is included in a memory scan
(
On
save all settings.

Using Auto Memory Store (AMS)

Follow these steps to have the HTX-242 scan through a selected
range and store active frequencies in memory.
1. Set the upper and lower scan limits (see "Setting the Scan-
ning Range" on Page 21).
2. Set the scanning step (see "Setting the Frequency Step" on
Page 19).
3. Set the squelch (see "Setting Volume and Squelch" on
Page 17).
4. Hold
The HTX-242 scans between the lower and upper scan lim-
its. When it detects a transmission, it checks all memories to
see if that frequency is already stored. If the frequency is not
in a memory, the HTX-242 stores the frequency in the lowest
unused memory, then resumes scanning. The HTX-242 con-
tinues auto store until all memories are used.
5. To stop auto store before all memories are used, press
DUP
Notes:
!
• The HTX-242 turns off tone squelch during auto store.
• Auto store does not work if all memories are used.
. The HTX-242 displays
, or press or
TUNE UP
. The HTX-242 displays
, or press or
TUNE UP
. Rotate , or press
TUNE UP
) or locked out of a memory scan (
for at least 1 second. Then press
F
, , , or .
MR CALL MHz
rC and the current receive
on the microphone, to
DOWN
tC and the current transmit
on the microphone, to
DOWN
to save all
CALL
. The HTX-242 displays
or on the microphone, to
DOWN
). Then press
Off
.
MHz
to
MR
,
VFO
29